This device is a temperature controller for use in spaces with air inflow and outflow. The Fan Controller keeps the room's temperature constant and the pressure low to prevent odor emission. This device is user-friendly, allowing you to adjust the needed temperature and pressure with just two buttons.
This device is a temperature controller for use in rooms with air intake and exhaust. The Fan Controller keeps the room temperature constant and the pressure low to prevent odour emission. This device is easy to operate, allowing you to adjust the temperature and pressure with just two buttons. This Fan Controller can also be used solely for air extraction.
No additional elements need to be attached as it comes ready to function. It includes a water-resistant cover or sealed lid, plug and a low power or voltage sensor which makes it perfect for rooms with dampness. The sensor comes with a 4-meter cable and can be extended up to 50 meters.
INSTRUCTIONS:
Place the air expulsion fan into the port labeled as FAN1 and the air intake fan into the port labeled as FAN2. Install the temperature probe, which comes with a 4-meter-long cable, in the preferred measurement location. Make sure not to place the probe near any heat or light source to avoid inaccurate measurements. If the cable is too short, it can be extended up to 50 meters maximum. Pay close attention when unplugging the power cable. Incorrect powering on or short circuits can destroy sensitive parts of the processor.
Insert the power cable into a 10A or 13A socket. The FAN1 fan should now operate at 20% to reach a low pressure. FAN2 will remain off. Adjust the temperature with the top button. If the temperature exceeds the set temperature by 2ºC, the fan will function at its maximum capacity to correct this. The second knob will operate FAN1 between 100% and 50%. FAN2 will operate at 50% of the setting for FAN1. If FAN1 has been set to operate at 100%, FAN2 will operate at 50% of its capacity; if FAN1 operates at 80%, FAN2 will operate at 40%. When the temperature reaches the desired value and FAN1 operates at the minimum of its capacity, FAN2 will automatically turn off.
Measurements and technical data:
Housing: WidthxHeightxLength: 130x80x70 mm
Controller: WidthxHeightxLength: 160x100x90 mm
Designed for: 2x600W / TRIAC 2x16A
Voltage: 230V / 50HZ
Digital Sensor: 5V measures temperature from -55ºC to +125ºC (-67ºF to +257ºC)
0.5ºC accuracy from -10ºC to +58ºC
Protection class: IP54
No customer questions for the moment.
This device is a temperature controller for use in spaces with air inflow and outflow. The Fan Controller keeps the room's temperature constant and the pressure low to prevent odor emission. This device is user-friendly, allowing you to adjust the needed temperature and pressure with just two buttons.
